Hide wires on wall3/23/2023 ![]() ![]() Step 3: Sliding This Wire Hider Against the Wall to Take MeasurementsĪ wire hider has two surfaces: the smooth concealing curved surface at the front and a flat surface at the back. You can then cut along these pencil marks with your hacksaw. Then, using a pencil, mark the two points, start and finish. Using your tape measure, measure the exact length you got from the exposed wires on the self-adhesive channel. If you already have a wire hider with a completely contrasting color to the walls, you can at least paint it to achieve this compatibility. For this reason, the self-adhesive wire channel’s color should be the same as that of the brick wall or as close to it as possible. You want to make your room as good-looking and welcoming as possible. Remember, the idea behind this painstaking process is to conceal your wires from your eyesight completely. Step 2: Mark and Cut the Self-Adhesive Wire Hider Now that you’ve understood the need for correct measurements, you can go ahead to measure the length of your exposed wires. Yes, that’s precisely what will happen if you don’t take your measurements correctly. You don’t want to leave the end parts of these wires sagging or with no allowance to finish installation at the end of this exercise. You have to be keen and careful when performing this activity to get the exact measurement of the exposed wires. Follow this simple guide on how to hide wires on your brick wall and conceal them fully from your sight. Hiding the wires on a brick wall will not only protect them from damage but also remove them from your eyesight. Screws to keep the self-adhesive wire channel in place.Aerosol can to blow dust out after drilling.You’ll be using a hacksaw to cut through the self-adhesive wire hider after measuring and marking the required length.A pencil that you’ll use to mark the required length on your wire hiders.This tool is where you’ll run the wires you’re hiding through to conceal them from the surface A self-adhesive wire channel that you’ll use as your wire hiders.It must be waterproof to completely prevent water and other spills from getting into contact with the wires you’re hiding. Caulk to fill in the holes after running your wires through it.Tape measure to measure the length of the exposed wires and a corresponding length on the wire hiders.Electric drills come in different sizes, capabilities, and prices, so you’ll choose one that best suits your need. It can also remove nails and other metals blocking its way. ![]() The electric hammer drill has excellent torque, enabling you to drive/drill through the brick wall at high speed.3 Get to Work Now! Tools Needed to Hide Wires on A Brick Wall.2.5 Step 5: It’s About Time You Put the Exposed Wires Inside Self-Adhesive Wire Channel.2.3 Step 3: Sliding This Wire Hider Against the Wall to Take Measurements.2.2 Step 2: Mark and Cut the Self-Adhesive Wire Hider.2.1 Step 1: Measuring the Length of Wires.1 Tools Needed to Hide Wires on A Brick Wall. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |